Monday, August 14, 2006

Model fight update 007

A little more progress on the spybot. I've settled on this one instead of the one with wings. I wasn't liking the bridge across the top but I didn't know what I didn't like about it. I just realized while I was looking at it that what I didn't like was that both ends (the sharp parts) were going to the same points on the inner ring where the fan is. Now I know that I want the top of the bridge to go to the outer point of the body.

This is the underside of the robot. It features a camera lens along with other robotronic stuff. I file that stuff under TBD. The half-dome on the other side contains a laser that can paint targets much like the Ion Painter in UT2004. This robot can watch you from the skies and call in a rain of firepower if you get out of hand.

I'm going in to detail about the components because I'd like to make a little commercial or brochure about the robot's features.

The fan assembly was made by modelling a rectangle, rounding the edges, extruding it (Push/Pull), then rotating a copy around the center point. SketchUp has a cool feature where you can type in multiplying commands into a VCB (Virtual Command Buffer?), so after I rotated the copy a few degrees (so now there were two blades), I typed x11 and it automagically made the duplicates, all rotated correctly and spaced evenly.

Everything else on the model was drawing basic shapes, Push/Pulling, etc.

I'm probably going to go between robots and modelling the 01Robotics complex just to mix it up a little.

4 comments:

John said...

So are you going to add nurnies to it.

Trey said...

I may go with greebles.

John said...

Wait...do you know what nurnies are?

Trey said...

Of course - why do you think I saw your nurnies and raised you greebles.

Do you know what greebles are?